Adrian M floor cleaning robot
My project is a floor cleaning robot. This robot is an essential around the house because it can clean messes that happen. This robot can and will make life easier.
Engineer
Adrian M
Undetermined
ie Electrical Engineering
Success Academy High School of the Liberal Arts
Adrian M
Grade
Incoming Sophomore
Final Milestone
My final milestone is the increased reliability and accuracy of my robot. I ameliorated the sagging and fixed the reliability of the finger. As discussed in my second milestone, the arm sags because of weight. I put in a block of wood at the base to hold up the upper arm; this has reverberating positive effects throughout the arm. I also realized that the forearm was getting disconnected from the elbow servo’s horn because of the weight stress on the joint. Now, I make sure to constantly tighten the screws at that joint.
Third Milestone
My final milestone is the increased reliability and accuracy of my robot. I ameliorated the sagging and fixed the reliability of the finger. As discussed in my second milestone, the arm sags because of weight. I put in a block of wood at the base to hold up the upper arm; this has reverberating positive effects throughout the arm. I also realized that the forearm was getting disconnected from the elbow servo’s horn because of the weight stress on the joint. Now, I make sure to constantly tighten the screws at that joint.
Second Milestone
First Milestone
My final milestone is the increased reliability and accuracy of my robot. I ameliorated the sagging and fixed the reliability of the finger. As discussed in my second milestone, the arm sags because of weight. I put in a block of wood at the base to hold up the upper arm; this has reverberating positive effects throughout the arm. I also realized that the forearm was getting disconnected from the elbow servo’s horn because of the weight stress on the joint. Now, I make sure to constantly tighten the screws at that joint.
My final milestone is the increased reliability and accuracy of my robot. I ameliorated the sagging and fixed the reliability of the finger. As discussed in my second milestone, the arm sags because of weight. I put in a block of wood at the base to hold up the upper arm; this has reverberating positive effects throughout the arm. I also realized that the forearm was getting disconnected from the elbow servo’s horn because of the weight stress on the joint. Now, I make sure to constantly tighten the screws at that joint.
LED Rainbow Light Show
My Starter Project is the increased reliability and accuracy of my robot. I ameliorated the sagging and fixed the reliability of the finger. As discussed in my second milestone, the arm sags because of weight. I put in a block of wood at the base to hold up the upper arm; this has reverberating positive effects throughout the arm. I also realized that the forearm was getting disconnected from the elbow servo’s horn because of the weight stress on the joint. Now, I make sure to constantly tighten the screws at that joint.